General initialization - Version: 1.0.0
Serdes initialization - Version: 1.0.2
Board H/W SKU Id is (4)
DDR3 Training Sequence - Ver TIP-1.27.0
DDR3 Training Sequence - Switching XBAR Window to FastPath Window
DDR3 Training Sequence - Ended Successfully
DDR3 Training Sequence - Start scrubbing
DDR3 Training Sequence - End scrubbing
BootROM: Image checksum verification PASSED
Board SKU ID is (4)
USB2.0 0: Host Mode
FPU initialized to Run Fast Mode.
FPGA: 1.5
DRAM Size: 512 MB
Xmodem file system is available.
USB EHCI 1.00
MTL NAND detected Device ID = 0xDA01
256 MiB
Using driver version 1 for media type 3
yaffs[9]: Initialization complete.
yaffs[10]: Initialization complete.
yaffs[11]: Initialization complete.
Base ethernet MAC Address: 70:1f:53:c4:60:80
The password-recovery mechanism is enabled.
*** The system will autoboot in 5 seconds ***
Send break character to prevent autobooting.
....................
Loading "flash:c2960l-universalk9-mz.152-5c.E/c2960l-universalk9-mz.152-5c.E.bin"...Verifying image flash:c2960l-universalk9-mz.152-5c.E/c2960l-universalk9-mz.152-5c.E.bin..............................................................................................................................................................................................................
Image passed digital signature verification
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
File "flash:c2960l-universalk9-mz.152-5c.E/c2960l-universalk9-mz.152-5c.E.bin" uncompressed and installed, entry point: 0x3000
executing...
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C2960L Software (C2960L-UNIVERSALK9-M), Version 15.2(5c)E, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Tue 18-Oct-16 23:59 by prod_rel_team
Board SKU ID is (4)
USB2.0 0: Host Mode
Initializing flash...
MTL NAND detected Device ID = 0xDA01
256 MiB
Using driver version 1 for media type 3
yaffs[8]: Initialization complete.
yaffs[9]: Initialization complete.
yaffs[10]: Initialization complete.
...done Initializing flash.
Checking for Bootloader upgrade..
Boot Loader upgrade not needed(v)
INIT: Pp init completed.
INIT: ASIC 0 phases init completed.
INIT: phases init completed.
INIT: features init completed.
POST: ACT2 Authentication : Begin
POST: ACT2 Authentication : End, Status Passed
POST: Thermal Tests : Begin
POST: Thermal Tests : End, Status Passed
POST: PortASIC Port Loopback Tests : Begin
POST: PortASIC Port Loopback Tests : End, Status Passed
Initializing Device Manager......done
Initializing OBFL Module......done
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco WS-C2960L-24TS-LL (Marvell PJ4B (584) v7 (Rev 2)) processor (revision D0) with 524288K bytes of memory.
Processor board ID FCW2132B7KS
Last reset from Reload
1 Virtual Ethernet interface
28 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 70:1F:53:C4:60:80
Motherboard assembly number : U58O342T02
Power supply part number : 341-100559-01
Motherboard serial number : FOC213189A8
Power supply serial number : LIT210524QR
Model revision number : D0
Motherboard revision number : 17
Model number : WS-C2960L-24TS-LL
System serial number : FCW2132B7KS
Top Assembly Part Number : 74-105855-02
Top Assembly Revision Number : A0
Version ID : V02
CLEI Code Number : CMMWJ00ARB
Hardware Board Revision Number : 0x02
Press RETURN to get started!
Mar 27 16:19:56.755: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
Mar 27 16:19:57.753: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
Mar 27 16:20:00.362: %SYS-5-CONFIG_I: Configured from memory by console
Mar 27 16:20:00.421: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C2960L Software (C2960L-UNIVERSALK9-M), Version 15.2(5c)E, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Tue 18-Oct-16 23:59 by prod_rel_team
Mar 27 16:20:01.165: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45.
Mar 27 16:20:02.352: %LINK-5-CHANGED: Interface Vlan1, changed state to administratively down% Generating 1024 bit RSA keys, keys will be non-exportable...
[OK] (elapsed time was 2 seconds)
Failed to generate persistent self-signed certificate.
Secure server will use temporary self-signed certificate.
Mar 27 16:20:19.148: %SSH-5-ENABLED: SSH 1.99 has been enabled
Switch>en
Switch#ter len 0
Switch#show run
Building configuration...
Current configuration : 1492 bytes
!
! Last configuration change at 16:20:10 UTC Fri Mar 27 2026
!
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Switch
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
!
!
!
!
!
!
!
!
!
!
!
spanning-tree mode rapid-pvst
spanning-tree extend system-id
diagnostic bootup level minimal
!
vlan internal allocation policy ascending
!
!
!
!
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
!
interface GigabitEthernet0/3
!
interface GigabitEthernet0/4
!
interface GigabitEthernet0/5
!
interface GigabitEthernet0/6
!
interface GigabitEthernet0/7
!
interface GigabitEthernet0/8
!
interface GigabitEthernet0/9
!
interface GigabitEthernet0/10
!
interface GigabitEthernet0/11
!
interface GigabitEthernet0/12
!
interface GigabitEthernet0/13
!
interface GigabitEthernet0/14
!
interface GigabitEthernet0/15
!
interface GigabitEthernet0/16
!
interface GigabitEthernet0/17
!
interface GigabitEthernet0/18
!
interface GigabitEthernet0/19
!
interface GigabitEthernet0/20
!
interface GigabitEthernet0/21
!
interface GigabitEthernet0/22
!
interface GigabitEthernet0/23
!
interface GigabitEthernet0/24
!
interface GigabitEthernet0/25
!
interface GigabitEthernet0/26
!
interface GigabitEthernet0/27
!
interface GigabitEthernet0/28
!
interface Vlan1
no ip address
no ip route-cache
shutdown
!
ip http server
ip http secure-server
!
!
line con 0
line vty 0 4
login
line vty 5 15
login
!
end
Switch#show ver
Cisco IOS Software, C2960L Software (C2960L-UNIVERSALK9-M), Version 15.2(5c)E, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Tue 18-Oct-16 23:59 by prod_rel_team
ROM: Bootstrap program is HAYWARDS boot loader
BOOTLDR: C2960L Boot Loader (C2960L-HBOOT-M) Version 15.2(5r)E1, RELEASE SOFTWARE (fc2)
Switch uptime is 1 minute
System returned to ROM by power-on
System restarted at 16:19:43 UTC Fri Mar 27 2026
System image file is "flash:c2960l-universalk9-mz.152-5c.E/c2960l-universalk9-mz.152-5c.E.bin"
Last reload reason: Reload command
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco WS-C2960L-24TS-LL (Marvell PJ4B (584) v7 (Rev 2)) processor (revision D0) with 524288K bytes of memory.
Processor board ID FCW2132B7KS
Last reset from Reload
1 Virtual Ethernet interface
28 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 70:1F:53:C4:60:80
Motherboard assembly number : U58O342T02
Power supply part number : 341-100559-01
Motherboard serial number : FOC213189A8
Power supply serial number : LIT210524QR
Model revision number : D0
Motherboard revision number : 17
Model number : WS-C2960L-24TS-LL
System serial number : FCW2132B7KS
Top Assembly Part Number : 74-105855-02
Top Assembly Revision Number : A0
Version ID : V02
CLEI Code Number : CMMWJ00ARB
Hardware Board Revision Number : 0x02
Configuration register is 0xF
Switch#